Heater hose fitting on dual quad intake
1 Attachment(s)
Anyone ever use a 90 degree fitting to avoid this debacle between the alt bracket (that doesn't align with the intake bolt/stud!), the fuel line and the heater hose??
|
yes I have one on my 4x2 intake for clearance issues.
http://i35.photobucket.com/albums/d1...ps0ogjhj75.jpg |
I'd be putting a 90 on there for sure Marlin. I put a Victor Jr on this SBC engine and didn't like its upward pointing water outlet so I added a 90 there as well. It's function over form sometimes.
http://i1218.photobucket.com/albums/...S%20Z28/90.jpg |
Nice! I'm not as crazy as I think most times, where did you get that fitting NorCam?
|
It was on my cars water pump when originally dressed as stock 302 but believe this is a 63-67 Vette fitting used on the 327 motors. I simply reused it but have found that GM Performance has them listed on their website (click link) and they are also offered at CamaroCentral and have seen a few on eBay (link) but would check to see of size is perfectly correct for your thread/hose size. They look very similar with that 6 sided design anyways.
http://i1218.photobucket.com/albums/...er%20Elbow.jpg |
Thank you!!
|
All times are GMT. The time now is 04:18 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.