[Ryan1969Chevelle]

Home run today!!

Wrapped up the rear end rebuild.

Red locktite for the pinion nut and cross shaft bolt, sealant on the pinion yoke splines, and white lithium grease on the seal surfaces. Then Lucas gear oil and GM posi additive:-) I even restored the original cover bolts. Done!!

My neighbor, Jamie and I installed the differential in the frame, that felt good!! I put the springs and insulators in. Next step is to paint the shocks and install. (I am using generic shocks as the repop spirals are so expensive and these are an easy upgrade in future if the need arises) I also may get drag shocks for PSMCDR)