Ok, so I might have taken the Bee off the rotisserie ( I'll update that here in the next few days). And I might have had the interior already out, sort of, looking for that build sheet. And the plasma cutter was already plugged into the wall....sooooooooo [img]<<GRAEMLIN_URL>>/hmmm.gif[/img]
Its a real simple process putting in a whole floor. Just some trimming along the edges to do, clean up the adjacent pans, make sure the metal is straight, place the floor in, mark a line around the edge for proper pan depth along the rockers, mark plug weld holes, remove pan, drill out plug well holes, place pan back in car, drill out pilot holes for self tapping screws to secure floor to rockers and frame rails, screw down floor, weld, grind welds flat, spray red oxide primer on floor, post on Yenko.net [img]<<GRAEMLIN_URL>>/grin.gif[/img] See? Easy! [img]<<GRAEMLIN_URL>>/thumbsdown.gif[/img]
Cheers [img]<<GRAEMLIN_URL>>/beers.gif[/img]