Darren sent me a PM and asked how to take this part of the shifter apart. I will answere here so "Buckeye Boy" Sam don't ax the same question later, pay attention Sam...
Drive out both roll pins ( to be replaced latter )
Then twist the shifter and pull out the large diameter spring.
Pull this gizmo stright out
Once that flat "T" is out, again twist the lever some and pull the small spring out, and watch for the washer. This washer is on the inside.
Good idea to take some notes and/or alot of pictures for reassembly. Pay attention to the position the shifter lever in relation to that "U" shaped spring housing... it can go together backwords...I did it...
even with the pictures.
Mike