[Ryan1969Chevelle]

Excellent idea Dave!!

Each of these items represents approx. one week.

Ryan

Repair Drivers side gas tank support (and trunk floor hole)
Repair Drivers side body mount (mid car)
Repair 4 speed hump (Original style)
Replace Driver side trunk floor (partial)
Replace Driver side trunk support
Replace Driver side trunk drop
Replace Passenger side trunk drop
Replace Passenger side quarter panel bottom edge
Remove 3 broken body mount bolts
Repair hood stopper hole (cowl)
Strip the floors and firewall
Paint the firewall and floors
Engine accessory restoration
Engine accessory restoration
Engine, bellhousing, clutch, trans, driveshaft install
Move the frame to my house
Body return to frame
Return rotisserie
Engine accessory restoration
Brakes, (And flex lines)
Steering
Rear End leak
Exhaust, O2 bungs, manifolds, head pipe tie in, and set up of all pipes.
Front clip disassemble
Front clip restore
Front clip restore
Front clip re-install
Front clip re-install Rad (re-core)
Fuel tank, sending unit, soft lines, and vent
Cooling System
Battery
Carburetor (Fuel system wrap up)
Fluids Wiper/washer motor
Test brakes, and suspension
Test and repair electrical systems
Test and repair electrical systems
Test run the whole car
Test run the whole car
Alignment
Certification
Drive it over to Al Stager's place and take him out for ice-cream
Trim
Jack
PSMCDR or bust.
OAI restore and install
Interior (Repair passenger door panel)
Interior (Head liner)
Interior (Carpet)
Make it pretty
Make it pretty
Make it pretty
Make it pretty
Get ready to transport to Chicago
MCACN 2018 "W31 Invitational Showcase"