Push clips for heater cable attachment

[Verne_Frantz]

Does anyone have a couple of these, or know where I can get them? I've tried McMaster-Car, Fastenal and MSC fasteners. No dice.
A little over 1/4" in dia and beveled.

Verne

[parkbrau]

http://www.heartbeatcitycamaro.com/s...ble-retainers/
part # 381700 I saw them on e-pay as well

[Lynn]

Amazing to me what gets ID'd as assembly line correct.

Haven't checked lately, but Ace Hardware used to have some of those (like HBC has) for about 10 cents a piece.

[parkbrau]

Here is the new GM part # 11501937 .49 cents at your GM dealer.

[Verne_Frantz]

Originally Posted by parkbrau

http://www.heartbeatcitycamaro.com/s...ble-retainers/
part # 381700 I saw them on e-pay as well

Thanks but those aren't anything like what I need. I doubt the new GM ones are either. I'll see if I can find a dealer who has one in stock so I can look at it.

Verne

I'm going to check the used dash board lever controls I have. I believe that end of the cable also uses the same clip.

[earntaz]

Originally Posted by Lynn

Amazing to me what gets ID'd as assembly line correct.

Haven't checked lately, but Ace Hardware used to have some of those (like HBC has) for about 10 cents a piece.

X2 -- still a real HARDWARE store unlike Home Depot and Lowes ... TAZ

[ds1]

I bought a bag of 50 at the auto parts store

[Verne_Frantz]

The dash lever assemblies use the same clips and I have plenty.
I hope I didn't waste anyone's time.

Thanks for the replies.

Verne