Charley Lillard
Reged: 04/10/00
Posts: 9971
Loc: Woodland, ca. US
|
|
I wish I did but no. I bought the # 3 Berger car from Bill.
|
thumper83
member
Reged: 03/08/08
Posts: 134
Loc: sault ste. marie on, canada
|
|
Oh ok I thought I read at one time you had this one lol sorry.
--------------------
1985 Monte Carlo SS
1986 Monte Carlo SS
|
HiHorse
enthusiast
Reged: 04/02/06
Posts: 265
Loc: Ontario
|
|
Does ZL1 Camaro #1 have its born with motor by any chance?
|
iluv69s
Reged: 04/28/07
Posts: 802
Loc: usa
|
|
I have no clue about the motor in this car, I doubt it since it was raced for years from day one. And I believe I remember reading that Porterfield found a replacement motor for the car. But ya never know as those motors have shown up after all these years and been reunited with the original cars in some cases.
Dont think it matters too much on this car does it??
I was really wondering what the original motor of this car would be worth if in fact it happened to be found nowadays.. 
|
Charley Lillard
Reged: 04/10/00
Posts: 9971
Loc: Woodland, ca. US
|
|
My understanding is Porterfield found the orig block and re installed it in the car a short while before he sold it. Kinda makes you not want to beat on it like he used to when it didn't have it.
|
HiHorse
enthusiast
Reged: 04/02/06
Posts: 265
Loc: Ontario
|
|
Would be nice to hear the story on how the block was found.
Edited by HiHorse (03/24/09 08:47 PM)
|
William
addict
Reged: 06/09/01
Posts: 648
Loc: New Berlin WI USA
|
|
The block was found while I was composing the COPO article on the CRG site. Billy P told me the shop that prepped the original engine for racing stamped some information on it in an obscure location. Any original ZL-1 block warrants attention but a late '68 casting is really rare; only Fred Gibb and Billy P knew what was stamped on it.
|
HiHorse
enthusiast
Reged: 04/02/06
Posts: 265
Loc: Ontario
|
|
You're saying the original block was identified by the machinist stampings? I'm assuming the original stamping on the deck are gone and there is no partial vin on the side?
|
William
addict
Reged: 06/09/01
Posts: 648
Loc: New Berlin WI USA
|
|
Yes-not only what was stamped but where.
Some ZL-1 Camaro engines had the VIN derivative stamped on the pad.
|
jsg1010z
stranger
Reged: 01/05/05
Posts: 1
Loc: paris, tx usa
|
|
Newcomer here,fwiw, Zl-1 number five had its derivative stamped on the vertical pad. The block was decked when I bought it.
|
Previous
Index
Next
Threaded
Edit
Reply
Quote
