Gold cad plating - EGR valve

[Jonesy]

Here are pics of an original EGR valve for my low mile 74 z/28. I was wondering if anyone has had any success replating this type of valve. If so, who did you send it to?
http://www.yenko.net/attachments/388683-EGRvalve1.jpg

[Jonesy]

Not even sure this can be done without taking it apart.
MT 7040299 very hard to find!

http://www.yenko.net/attachments/388684-EGRvalve2.jpg

[Jonesy]

http://www.yenko.net/attachments/388685-EGRvalve3.jpg

[CamarosRus]

In my opinion the "gold" plating you want is Yellow Zinc DiChromate...............

[wheelhop]

You could try Steve Gregori @ Brake Boosters, Inc.

[Jonesy]

Thanks, I think I may give Steve a call, couldnt hurt. Thanks Chuck for the correct finish.