bcmiller
06-14-2011, 12:07 PM
I started this thread on the CRG site a while back.
http://www.camaros.org/forum/index.php?topic=7861.0;all
I have been working with Kurt and Ed with CRG and we have been able to put some information together. We are trying to get a section ready about driveshafts. If anyone has an original driveshaft and you could get and post the following information, it would be greatly appreciated.
Year of car
Norwood or Los Angeles assembly
Month and week of vehicle assembly
Engine
Transmission
Driveshaft length (measured center of u joint to center of u joint)
Type of attachment to pinion yoke. There are two types: U bolts and the strap and bolts method.
Code stamped on front of passenger side axle tube.
Paint stripes and a picture (if possible)
Post in this thread if you want. If you would rather not post, but still contribute, send an email to me please. Especially interested in Big Block cars...manual trans or TH400. Thank You.
http://www.camaros.org/forum/index.php?topic=7861.0;all
I have been working with Kurt and Ed with CRG and we have been able to put some information together. We are trying to get a section ready about driveshafts. If anyone has an original driveshaft and you could get and post the following information, it would be greatly appreciated.
Year of car
Norwood or Los Angeles assembly
Month and week of vehicle assembly
Engine
Transmission
Driveshaft length (measured center of u joint to center of u joint)
Type of attachment to pinion yoke. There are two types: U bolts and the strap and bolts method.
Code stamped on front of passenger side axle tube.
Paint stripes and a picture (if possible)
Post in this thread if you want. If you would rather not post, but still contribute, send an email to me please. Especially interested in Big Block cars...manual trans or TH400. Thank You.