Appliance Headers...again

[bbbentley]

I just acquired these headers. I read up what I could about Appliance from other posts. I am hoping the more experienced on here can tell me more? Like how old these may be? Are they Appliance (consensus)? and, where is the part number located? They are for a BBC. Guy I got them from said they were either on his 67 Chevelle or his 68 Camaro, but could not remember?:youguysrock:

[Day2_69Z]

Most likely Appliance.
More than likely Chevelle vs Camaro.
The right side (passenger side) has tubes past the flange end towards the firewall where Chevelles have much more room.

[1967Z28]

This link shows Appliance headers for Chevelle plus where the p/n is stamped. Yours are close but not exactly the same.

http://www.yenko.net/forum/showthread.php?p=1293358#post1293358

I don't think they will work on a '67-'69 Camaro because of the #7 tube. It looks like it would interfere with a Camaro steeering box/pitman arm.

[bbbentley]

This link shows Appliance headers for Chevelle plus where the p/n is stamped. Yours are close but not exactly the same.

http://www.yenko.net/forum/showthread.php?p=1293358#post1293358

I don't think they will work on a Camaro because of the #7 tube. It looks like it would interfere with a Camaro steeering box/pitman arm.

Thank you. I read that post, but I did not see where the part number location was mentioned. And, I compared mine to those in the post, and mine are not like those in the post , agree.

[earntaz]

I just acquired these headers. I read up what I could about Appliance from other posts. I am hoping the more experienced on here can tell me more? Like how old these may be? Are they Appliance (consensus)? and, where is the part number located? They are for a BBC. Guy I got them from said they were either on his 67 Chevelle or his 68 Camaro, but could not remember?:youguysrock:

Have to agree -- they look like Appliance ... TAZ

[whitetop]

Could also be early Mr Gasket or Blackjack-both had the square header flange. Blackjack still had the square header s flange well into the 80's.

Part number is either on the flange or down by the collector

[bbbentley]

Thank you. I read that post, but I did not see where the part number location was mentioned. And, I compared mine to those in the post, and mine are not like those in the post , agree.
Never mind. I see now where the part # is. Even a blind hog gets lucky and finds an acorn once in while!

Edit: Ok, found what I was after. Much thanks to all and thank you Jon, Taz others. By the number found! and comparing to the catalog, it is Appliance and for 1970-1 Camaro BB.

[earntaz]

Triple B -- here is a shot of the RH Appliance for my 70' Nova ... TAZ

[mockingbird812]

Great shot TAZ. A man and his engine!

[Mr70]

By the number found! and comparing to the catalog, it is Appliance and for 1970-1 Camaro BB.

Let us know if you post these up for sale. :D

[ssl78396]

Take a look...