Survivor unrestored assembly line Hardware

[Enoch]

Camaro rear deck lid and front header emblem mounting pal nuts. Excellent unrestored condition with clear p a l stamping on the flange. Set of 5. $35 a set ship to the lower 48 if paid with PayPal friends and family. 5 sets available

[Enoch]

Small block starter brace mounting hardware. Mounting hardware F head marking brace to block bolt stamps bland mounting not and GL head marking heat shield mounting bolt excellent on restored condition on all three pieces $50 a said shift to the lower 48 if paid with a Pal friends and family two sets available

[Enoch]

A body rear exhaust hanger mounting bolts. TF head marking these are NOS pieces. $40 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

67 through 69 Camaro front spoiler mounting bolts and nuts. He had marking bolts and correct 1024 nuts with small washer. Left all the dirt and grunge on them for perfect original patina. Excellent original condition no rust or pitting at all. $60 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

67 69 Camaro rear spoiler mounting nuts. Large washer nuts have anchor stamp on the underside. All original unrestored condition. Three sets available $60 a set ship to the lower 48 if paid with PayPal friends and family.

[Enoch]

65 through 74 396 427 454 balancer mounting bolts with special thick lock washer and oversized thick flat washer. Wagon Wheel head marking. Excellent condition as nice as you're going to find. $60 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

Coil mounting bolts and screw. He had marking with dimple. $35 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

65 through 74 big block fuel pump mounting bolts, B&H head marking, and L stamped fuel pump push rod plug. Excellent unrestored condition. $70 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

Fan to fan clutch mounting bolts. A head marking. Excellent unrestored condition. The reproduction houses all sell studs and nuts for this application. These are assembly line pieces. Very nice very hard to find good Originals. $45 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

Original wire style distributor hold down. The originals are unique compared to the reproductions. The whole down plate has a raised pad under where the bolt goes you can see the two distinct lines on either side of where the head is on the boat. RSC head marking excellent unrestored condition $40 ship to the lower 48 if paid with PayPal friends and family.

[Enoch]

660 thermostat housing mounting bolts. Long bolt has C head marking short bolt has rbw head marking. Excellent unrestored condition. $35 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

Fan clutch to water pump Hub mounting bolts. S head marking. Excellent unrestored condition still have a lot of patina with their original plating on them. $50 shift to the lower 48 if I paid with PayPal friends and family.

[Enoch]

Big block crankshaft pulley mounting bolts. RSC head marking. Excellent unrestored condition. $30 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

Big block short water pump mounting bolts and a IR stud. TR head marking. Excellent unrestored condition. Very nice these are usually rusted. $50 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

Small block big block 4-speed inspection cover mounting bolts e l in three circles. Very nice original condition. $30 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

69 to 72 small block long water pump alternator mounting hardware set. All CH head marking. The long pivot bolt is grade 8 and the three bolts that attach the alternator triangle bracket to the water pump are 3/8 16. The alternator adjusting bolt is 5/16 18 and the special Finn head bolt that holds the strap bracket to the back for the spacer on the long Bolt is also 5/16 18 but with a thin head. All perfect excellent kit free unrestored condition. $60 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

Camaro Chevelle Nova trunk hinge to trunk mounting bolts. With original blue paint. Looks like LeMans blue. Rbw head marking. $45 is set shipped to the lower 48 if paid with PayPal friends and family. Very hard to find with original paint

[Enoch]

Small block aluminum valve cover bolts. M head marking. Two sets available. Both sets excellent unrestored condition. Will clean up perfect if you want to play them but fine just as they are. $90 a set shipped to the lower 48 if paid with PayPal friends and family. If you want both sets it's $150.

[Enoch]

69 through 72 small block crankshaft pulley mounting bolts. Rbw head marking. Excellent unrestored condition. $35 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

Battery clamp hold down Bolt. Two different head markings. Both with e l one has two circles one has three circles. $30 each shipped to the lower 48 if paid with PayPal friends and family.

[my70454ss]

PM sent

[Enoch]

Very rare hard to find TCS stud. They do not reproduce this stud. It has o stamped on the tip. 50 shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

69 Camaro rear bumper guard mounting hardware. The larger 3/8 bolts attach the bumper guard to the bumper and the smaller 5/16 bolts attach the bumper guard to the lower Valance.
Two sets available
(E)
F
$45 a set shipped to the lower 48 if paid with PayPal friends and family.

[Enoch]

Negative ground to alternator bracket mounting bolt and star washer. Elh and marking bolt and special large external tooth lock washer. $40 shipped to the lower 48. If paid with PayPal friends and family. 5 sets available.

[Enoch]

69 Camaro front bumper mounting hardware. For large a head marking bolts attach the brackets to the subframe. The 3D bolts with captured flat washers attach the bumper brackets to the fender extensions. The small a head marking bolts attach the extension bracket to the main bracket. Extremely nice original set. You won't find nicer and they don't reproduce these like this. $100 shipped to the lower 48.

[Enoch]

Very late 69 through 72 locking motor mount bolts [] head marking with original under-sized lock washers and tapered lock nuts. Excellent unrestored condition. $40 ship to the lower 48 if paid with PayPal friends and family

[Enoch]

Cleaning out the inventory. Open to all offers. Thanks syc

[Enoch]

65 through 74 unrestored big block oil pan mounting bolts. Original L head marking. Excellent unrestored condition.SOLD OUT $100 shipped the lower 48 if paid with PayPal friends and family. Open to offers SOLD OUT

[Enoch]

70-72 TCS solinoid +vacuum clip studs. LS6 L78 LT1 the tops of the studs have a slash stamp. 40 for the pair shipped to the lower 48 if paid with PayPal friends and family

[Enoch]

I have multiple sets of the rest of the hardware listed in the thread hrer so if interested in accepting best offers

[mike1971]

Pm sent

[Hrlyfxdl]

PM sent Rich, just following up on my order from awhile ago. Thanks

[Edgemontvillage]

Does anyone have a phone number for "Enoch" - Rich Pasqualone ? I purchased some items and he is no longer responding to emails. Please PM. Thanks.

[BCreekDave]

He sells as originalcorvette
https://www.ebay.com/usr/originalcorvette?_trksid=p2053788.m1543.l2754
on eBay. Maybe try him there?

[Enoch]

Lloyd email sent with # to text...best way to get in touch. Thanks

[Edgemontvillage]

He sells as originalcorvette
https://www.ebay.com/usr/originalcorvette?_trksid=p2053788.m1543.l2754
on eBay. Maybe try him there?

Thanks for your help.

[1967Z28]

Rich, I have no cell phone and can't text. You advertised a flat handle '68 Z dipstick and sent me a round handled one. I complained. You said you would send me the correct one and never did. Please make things right. I am happy to return this dipstick I did not ask for in exchange for what you advertised.

[protree68]

Please send my overflow hose I bought

[Edgemontvillage]

Rich, I have no cell phone and can't text. You advertised a flat handle '68 Z dipstick and sent me a round handled one. I complained. You said you would send me the correct one and never did. Please make things right. I am happy to return this dipstick I did not ask for in exchange for what you advertised.

PM Sent.

[Steve Shauger]

I've been in contact with Rich, and understands he needs to improve his shipping and communication.

[Hrlyfxdl]

I know he ran into some rough weather awhile back. How jeds ok, all the communication sad. Really good up until recently. I'd bought a lot of hardware from him, good guy. Maybe he just got behind. I'll touch base with him via text.

[1967Z28]

Steve, he needs to send what he advertised he had. Not waste my time and money sending me something I didn't ask for.

I've been in contact with Rich, and understands he needs to improve his shipping and communication.

[Edgemontvillage]

I've been in contact with Rich, and understands he needs to improve his shipping and communication.

Steve, thanks for reaching out to Rich. He has now contacted me regarding my order which is more than 60 days outstanding. The last shipment was apparently lost in transit and the order was reportedly re-shipped. Will keep you posted.

[scuncio]

Appears he is still filling orders on eBay, for what that’s worth.

[Hrlyfxdl]

Rich, I'd sure like to get my order as well. It's been awhile.

[Edgemontvillage]

My March order has arrived.