Nothing but brass. Various rare brass fittings Oil, Fuel Temp

[Enoch]

THREAD CLOSED.......all listed items were either sold or moved to another thread


Making a thread shortly for original NOS and assembly line installed brass components. individual descriptions and pricing to follow

[Enoch]

2 original 4 bolt main big block weather head stamped brass oil line to block fittings. Not being reproduce with the original weather head stamping. For original Concentric machining marks on surface. $60 each PP FF
BUSHING ON THE LEFT IS ************ SOLD ************

[Enoch]

Extremely nice 45 degree 2 bolt main big block brass oil line to block fitting. Whether head stamping. Not being reproduce correctly. Very hard to find. $80. PPFF
***********SOLD *************

[Enoch]

Very nice 45 degree with pipe extension brass oil line to block fitting. Whether head stamp. Again not being read produced correctly. $35 Ppff

[Enoch]

Original 2 bolt main big block low horsepower straight oil pressure line brass bushing to block. Very nice original peace. $35 PPFF

[Enoch]

Small and big block oil pressure line compression fittings. And bushing. Sitting on the left is NOS <CP> PAT PEND stamped. $35. I have 10 left. Fitting on the right as a weather head stamp on the lower bushing. Very very hard to find. $45. Ppff

[Enoch]

Next up two more original assembly line installed small-block and big-block brass oil line compression fitting and bushings. Both bushings have Weatherhead stamped on them. Very rare pieces. $45 each ppff

[Enoch]

Next up 4 very nice small block tall oil pressure line to block fittings. Three of them are pH stamped one of them has no markings. 3 that are stamped are $45 each and one with no markings is $30. Very nice very hard to find Originals with correct era stampings.

[Enoch]

Next up are two original Swedge lock bushing fittings for the oil line.

The bushing on the left is NOS and has Weatherhead stamping. Also the correct 5/16 hex fitting is NOS. That setup is $50. ******* SOLD ********

The bushing on the right has no stamping but is an assembly line piece and comes with an NOS 5/16 hex fitting. $30 ppff

[Enoch]

Next up 65 66 early 67 396 427 brass 90 degree fuel pump elbow, 3/8 line. Two of them weather head stamped assembly line pieces $45 each one NOS Eaton stamped $50. Ppff

[Enoch]

Assembly line installed AC Delco 12 volt threaded temperature sender. This is the sender that screws into the side of the head. Very nice original piece with correct upside-down wording stamped on unit. $45 ppff
************SOLD************

[Enoch]

B&N stamps rubber vulcanized oil line clip and rbw head marking bolt that attach it to the driver side rear head boss. This clip and bolt attaches the oil lines as it goes down to the fitting. Very nice unrestored Originals. $45 ppff

[Enoch]

Original tach-drive distributor brass coupler $25

[Enoch]

1967 through 1969 tripower fuel line brass block. Weatherhead logos and original machining marks. Excellent unrestored condition. Incorrect replacements sell for $35. This is also correct for Dana / Nicky cars with tri-power setups.$50 Ppff
************ SOLD ************