Tilt steering column

[Canuck]

I am restoring and installing a tilt column in my 68 Z28. I have run into a roadblock in getting the tilt column dismantled. I have done a dozen 70 and later columns but this is a first attempt at a non locking column. Can anybody direct me to a correct diagram or resto thread.
Paul

[hogdaddy]

PM sent.

[parkbrau]

Give these pages a look over: http://jimshea.corvettefaq.com/?cat=10

[Canuck]

Thanks for the help. The tip that I was looking for was that a puller is necessary to trove the collar to access the mechanism.

[L78racer]

you need Kent Moore J-22598 to get the collar off.

https://picclick.co.uk/Kent-Moore-J-22598-Steering-Column-Cover-Remover-Specialty-362326403184.html

[Canuck]

I tried today with a claw puller but the case tapers around the back of the collar. Looking for a good diagram that shows how a puller is supposed to attach.

[L78racer]

the curved 'jaws' fit under the rolled upper lip of the collar. i've used the tool and it works.