AnthonyS
12-13-2021, 02:48 PM
Hi Gang, I have a recent take off set up from a 1967 Camaro disc brake car.
Many photos below to describe the complete condition. Typical surface rust, but nothing fatal IMHO - these are very usable cores, again, IMHO.
8515 booster dated 82 - March 22 or 23
5460346 master cylinder stamped WT - takes a bit of imagination to see the stamp in the photo - but I think I can - see photo. Comes with a "service with Delco parts" lid still installed - I didn't remove bail wires (to check cast date) or open to inspect. I'll also include a core (bent wavy, rusted and buffed) J1703 lid too, as shown. Looks like the set up may've been updated long ago with some 69 parts? Not sure.
$800 PPFF for everything shown plus shipping & insurance if required.
Cheers all,
Anthony
Many photos below to describe the complete condition. Typical surface rust, but nothing fatal IMHO - these are very usable cores, again, IMHO.
8515 booster dated 82 - March 22 or 23
5460346 master cylinder stamped WT - takes a bit of imagination to see the stamp in the photo - but I think I can - see photo. Comes with a "service with Delco parts" lid still installed - I didn't remove bail wires (to check cast date) or open to inspect. I'll also include a core (bent wavy, rusted and buffed) J1703 lid too, as shown. Looks like the set up may've been updated long ago with some 69 parts? Not sure.
$800 PPFF for everything shown plus shipping & insurance if required.
Cheers all,
Anthony