Drive Shaft Needed

[bergy]

Looking for a nice, correct drive shaft for my 67 BB automatic Camaro. According to CRG - needs to be 49.96" long (eye center to eye center) and the yokes should be in line (not clocked)

[j1m68]

I have one off a 68 Camaro 396 4 spd car. It measures 50.5" eye center to eye center. Joints are in line also.

[bergy]

Thanks for replying. In addition to the length, the yokes are different on that one. Any others out there?

[Salvatore]

Check with Heartbeat City or Bob Harris. Maybe even Fred Schempp or Dave Valentin
has something like that.

[X66 714]

Thanks for replying. In addition to the length, the yokes are different on that one. Any others out there?

It sounds like you require the drive shaft with the injected u-joint locks (Saginaw) instead of the snap ring type (Spicer), correct....Joe

[j1m68]

Yes you are correct about the yoke also. Mine has the 1 1/2" diameter one.

[camarodude67]

I have a 1967 Camaro Gm driveshaft from a L78 but is clocked if that is the correct terminology.

[bergy]

Yes - injected U joints Joe. I have the original, but it's not in great shape. Hoping to find a really nice one, or may have to re-tube what I have :-(

[bergy]

Anybody have one? I've seen some with the yokes actually clocked, but the ends have to be nyloc type. Any out there?

[luv2sixty9]

I should have you covered. See you on Tuesday. Dave