PDA

View Full Version : 1969 Camaro trunk divider 2.0

Danzo
06-18-2023, 12:26 AM
I just could not accept the ones offered. Made my own.
Doc
X66 714
06-18-2023, 02:49 AM
Where did you get the board?....Joe
R68GTO
06-18-2023, 10:22 AM
Well done!
Danzo
06-18-2023, 12:46 PM
Where did you get the board?....Joe

Joe, sourced it from a friend of mine who does cabinet making.
Doc.
X66 714
06-18-2023, 01:23 PM
Thank you. Didn't think about that....Joe
Mr70
06-18-2023, 01:47 PM
Joe, sourced it from a friend of mine who does cabinet making.
Doc.


I was considering that too,as I was looking at older CRT TV & Stereo bookcase entertainment cabinets sold during the 1980'-90's in a secondhand store recently.
Their backing was covered in this stuff.
Good job.
Danzo
11-26-2023, 02:45 PM
Installed.
Doc
X66 714
11-26-2023, 02:54 PM
The vinyl was glued to the metal & the devider just sat on the hooks....Joe
Danzo
11-26-2023, 09:28 PM
Joe, agree with you 100%, but this is how this one was found. So it was restored to same.
Doc
dykstra
11-27-2023, 11:42 AM
Looks great!!
Jonesy
11-27-2023, 02:42 PM
That looks really good. You should start mass producing these :D
Danzo
11-28-2023, 12:36 AM
That looks really good. You should start mass producing these :D

I don't think there would be a market,
CamarosRus
12-05-2023, 07:47 PM
Doc, My contact at REM Mfg in PA wrote me......................

"We actually made that for him (Doc)! That piece is obviously die cut. We specially printed that board one side black one side tan. The only thing “Doc” did was draw the yellow lines and markings."

I am a REM Dealer and can sell that Divider to anyone at a lower cost than the BIG online sites