Stupid I’d help please

[Charley Lillard]

Found on shop floor and know I have seen it before but can’t remember where

[enio45]

Muffle Bearing Grease Tool .....

[dykstra]

Do you own any guitars Charley? It almost looks like a guitar bridge pin?

[big gear head]

Kind of looks like a pin that holds things together until you get ready to install it. Then you remove the pin and discard it.

[Too Many Projects]

Nothing I recognize. Which vehicle did you drive out/in last ? Might be a place to start looking underneath...:dunno:

[markjohnson]

I’m thinking door hinge pin. Also, garage door hardware possibly.

[PeteLeathersac]

'

Commercial Washroom Stall Hinge Pin, made to break w/ abuse before other more extensive damage happens?:hmmm:
:beers:
~ Pete

.

[George H]

Shotgun magazine plug that limits the number of shells in the gun?

[Charley Lillard]

None of the above. It is driving me crazy as I keep thinking about it .

[Mr70]

It could be..

DU_Gd623HJo

[Lynn]

You did ask for stupid help. The usual gang of idiots came through. As a charter member of the idiot club, I will give it a shot.

My guess would be a hinge pin. Obviously light duty. You been messing with a light duty cabinet, locker or even a plastic tote with hinged lid or lids?
Mail box?
Toilet seat or lid?
Height adjustment on a mower?
Plastic case for a power tool?
Garbage can?

[enio45]

i see something like this on my small outdoor shed hinge cover, also a bit smaller on the tap and fie set cover - seem anything plastic hinge related.

[TimG]

That video was hilarious ��

[mssl72]

It's a thing for a thing.

[big gear head]

Pin for a cooler lid hinge?

Maybe one of your friends decided to play a trick on you and tossed a random part on your floor just to mess with you.

[LetsFNgo]

It’s a dckfer.

[ls6owner]

Looks kinda like the aligning pin that comes with a new Hurst shifter to set the adjustment? When done, it is removed.

[Too Many Projects]

Alignment pin is 1/4", that plastic piece appears to be larger than that...:hmmm:

[Charley Lillard]

The Hurst alignment pins I have used are more like 1/4" and have a 90 degree bend at the end. This is much larger diameter.

[Lynn]

Looks like 3/8 or 10mm in the pics.

[olredalert]

----Charley wouldn't have a regular cooler. Bet there's a walk in cooler somewhere in the man cave!....Bill S

[Igosplut]

----Charley wouldn't have a regular cooler. Bet there's a walk in cooler somewhere in the man cave!....Bill S

My shop beer cooler Bill

https://i.postimg.cc/yNgwtsWq/62334184779-4-D7-F2-C67-5-F06-4760-B4-B5-D6-A60279-CEF0.jpg (https://postimages.org/)

[olredalert]

My shop beer cooler Bill

https://i.postimg.cc/yNgwtsWq/62334184779-4-D7-F2-C67-5-F06-4760-B4-B5-D6-A60279-CEF0.jpg (https://postimages.cc/)

----Love it!!!....Bill S