View Full Version : Rebuilding 186 heads. Need source for parts.
DarrenX33
06-08-2004, 07:47 PM
I have a set of bare 186 heads that I need to get built. I am going with Manley valves but was wondering if there were any recommendations for springs and rocker arms. These are for the 302.
Salvatore
06-09-2004, 05:48 AM
We used the stock pressure 302 springs from Manley. I also used the roller TIP rockers from Crane. They fit under the valve covers. Just do a little cleaning in the ports and runners, shim your spring heights and use steel clips and retainers. Will go to 7000 rpm's all day. Sam
hvychev
06-15-2004, 09:36 AM
Thats ok Sam.....Darrens car has never seen over a 5,000 rpm rev.... http://www.yenko.net/ubbthreads/images/graemlins/haha.gif
DarrenX33
06-15-2004, 05:59 PM
That hurts.
Salvatore
06-17-2004, 01:59 AM
Below the belt that comment HUH! http://www.yenko.net/ubbthreads/images/graemlins/haha.gif http://www.yenko.net/ubbthreads/images/graemlins/haha.gif I get ya Frankie!!! http://www.yenko.net/ubbthreads/images/graemlins/eek.gif
vBulletin® v3.8.11, Copyright ©2000-2024, vBulletin Solutions Inc.