restoring frame questions

[rusted goat]

Few questions about restoring a frame for a concours show car (71 Judge)
1. stainless brake and fuel lines
2. poly control arm bushings
3. bolted in upper balljoints
4. powercoating frame and a arms
5. exhaust stainless
I can go with rubber and steel but I was wondering what everyone else is doing in these areas

Thanks this site just pushed me into getting started on a long overdue restoration

[Alss]

Just finished my COPO frame..painted frame and arms, stainless lines, bolted ball joint ( for now ), poly bushings and I'm not sure what the Gardener exhaust sytem is but that is what I am going to use. I have doen a frame in powder coat and it is very nice but a good frame is a must to start with. good luck.

Check it out:
http://www.yenko.net/ubbthreads/showflat.php/Cat/0/Number/117334/an/0/page/0#117334

ALbert