70 Chevelle steering shaft finish

[70LS6454]

What color should the coupler(the parts that bolts to the steering column) and the shaft itself susposed to be?I have seem some that are natural and some that are black are either correct?If its all natural what the spray can color that I can use?

thanks

[Mr70]

Ray
What plant is your car from?
I've seen a few Van Nuys & Arlington built with natural finish,but the natural finish could've been due to Heat/Moisture peeling the black coat.They weren't very decisive examples at the time.
Atl.-Balt.-Flint-Kan.& Oshawa plants seem to favor the Black.
I have a Leeds factory photo engine shot showing both components in Black.
Krylon #1613 looks good w/a light satin top coat afterwards.
Tape off the Rubber boot,interior spring,and exterior clip on the Coupler.

[70LS6454]

Rick, my car was built at the Flint plant.Thanks for the info.

Ray

[YENKO DEUCE REGISTRY]

Eh! What the hey, paint it all natural from a spray can and be done with it http://www.yenko.net/ubbthreads/images/graemlins/grin.gif