Forum: Member's Rides
Today, 12:46 AM
|
|
Replies: 143
Views: 53,157
|
|
Forum: Chevrolet
Yesterday, 10:21 PM
|
|
Replies: 8
Views: 559
|
|
Forum: Pontiac
Yesterday, 07:01 PM
|
|
Replies: 197
Views: 91,208
|
|
Forum: Supercar/Musclecar Discussion
Yesterday, 04:41 PM
|
|
Replies: 10
Views: 1,000
|
|
Forum: Supercar/Musclecar Discussion
Yesterday, 04:40 PM
|
|
Replies: 10
Views: 1,000
|
|
Forum: Supercar/Musclecar Discussion
Yesterday, 03:47 PM
|
|
Replies: 72
Views: 22,049
|
|
Forum: Fred Gibb Chevrolet
Yesterday, 03:24 AM
|
|
Replies: 2
Views: 308
ZL-1 #10 engine located
Rebuilt as a 454 and configured for racing, not run. Block was decked, con VIN stamp remains on the side of the block. Has original heads.
Owner would like to see it reunited with the chassis. I...
|
|
Forum: Supercar/Musclecar Discussion
06-19-2024, 11:44 PM
|
|
Replies: 3
Views: 477
|
|
Forum: Lounge
06-19-2024, 11:29 PM
|
|
Replies: 17
Views: 938
|
|
Forum: In Memoriam
06-19-2024, 05:48 PM
|
|
Replies: 13
Views: 831
|
|
Forum: Mopar
06-19-2024, 02:48 PM
|
|
Replies: 14
Views: 2,914
|
|
Forum: Mopar
06-19-2024, 02:37 PM
|
|
Replies: 14
Views: 2,914
Moving on to the engine, it was evident that it...
Moving on to the engine, it was evident that it was filthy, 50+ years of grime, grease and makeshift repairs, it was leaking from every conceivable orifice, but it ran very well, so I decided to put...
|
|
Forum: Mopar
06-19-2024, 01:46 PM
|
|
Replies: 14
Views: 2,914
Continuation from the post yesterday. After...
Continuation from the post yesterday. After examining the internals of the trans, everything looked good, so I cleaned it up, replaced the input shaft and output shaft seals and reinstalled the top...
|
|
Forum: Technical & Restoration
06-19-2024, 01:32 PM
|
|
Replies: 5
Views: 528
1969 RS/Z28- Correcting Things
1) Installed correct height springs
2) Removed this hideous aftermarket am/fm cassette. Luckily nothing was hacked up when installed. It was a rats nest of wires. There something about removing...
|
|
Forum: Mopar
06-18-2024, 09:23 PM
|
|
Replies: 14
Views: 2,914
Well, I've been hard at work on this Truck for...
Well, I've been hard at work on this Truck for the past few months. I'll add posts as I get time to show the progress. I was able to fix all of the oil leaks, replaced the timing set, cleaned the...
|
|
Forum: Supercar/Musclecar Discussion
06-18-2024, 12:59 AM
|
|
Replies: 1,104
Views: 1,676,504
|
|
Forum: Supercar/Musclecar Discussion
06-18-2024, 12:10 AM
|
|
Replies: 1,104
Views: 1,676,504
|
|
Forum: Supercar/Musclecar Discussion
06-17-2024, 11:52 PM
|
|
Replies: 1,104
Views: 1,676,504
|
|
Forum: Supercars/Musclecars-For Sale
06-17-2024, 03:36 AM
|
|
Replies: 4
Views: 670
|
|
Forum: Supercar/Musclecar Discussion
06-16-2024, 07:19 PM
|
|
Replies: 1,104
Views: 1,676,504
|
|
Forum: Supercar/Musclecar Discussion
06-16-2024, 06:34 PM
|
|
Replies: 11
Views: 3,719
Old thread but in case anyone follows, the...
Old thread but in case anyone follows, the 136370A155771 Chevelle is now "restored". It is in fact an original LS6 with original buildsheet though none of the drivetrain, sheet metal (other than...
|
|
Forum: Lounge
06-16-2024, 04:30 PM
|
|
Replies: 7
Views: 303
|
|
Forum: Supercar/Musclecar Discussion
06-16-2024, 03:39 PM
|
|
Replies: 1,104
Views: 1,676,504
230691
My 67, I’ve had people tell me it’s a little to high in the rear but I like the look. It has a set of aftermarket mono’s on it I bought from D&R back in 1995.
|
|
Forum: Member's Rides
06-16-2024, 02:14 PM
|
|
Replies: 212
Views: 179,438
|
|
Forum: Lounge
06-16-2024, 01:15 PM
|
|
Replies: 7
Views: 303
|
