Forum: Fred Gibb Chevrolet
Today, 03:24 AM
|
|
Replies: 2
Views: 248
ZL-1 #10 engine located
Rebuilt as a 454 and configured for racing, not run. Block was decked, con VIN stamp remains on the side of the block. Has original heads.
Owner would like to see it reunited with the chassis. I...
|
|
Forum: Mopar
Yesterday, 02:48 PM
|
|
Replies: 14
Views: 2,893
|
|
Forum: Mopar
Yesterday, 02:37 PM
|
|
Replies: 14
Views: 2,893
Moving on to the engine, it was evident that it...
Moving on to the engine, it was evident that it was filthy, 50+ years of grime, grease and makeshift repairs, it was leaking from every conceivable orifice, but it ran very well, so I decided to put...
|
|
Forum: Mopar
Yesterday, 01:46 PM
|
|
Replies: 14
Views: 2,893
Continuation from the post yesterday. After...
Continuation from the post yesterday. After examining the internals of the trans, everything looked good, so I cleaned it up, replaced the input shaft and output shaft seals and reinstalled the top...
|
|
Forum: Technical & Restoration
Yesterday, 01:32 PM
|
|
Replies: 5
Views: 488
1969 RS/Z28- Correcting Things
1) Installed correct height springs
2) Removed this hideous aftermarket am/fm cassette. Luckily nothing was hacked up when installed. It was a rats nest of wires. There something about removing...
|
|
Forum: L78/L89 specific Forum
Yesterday, 01:02 AM
|
|
Replies: 355
Views: 171,972
I went to my local cars and Coffee Father's day...
I went to my local cars and Coffee Father's day and a local photographer took these photos of my car. Luckily where I live there are Cars and Coffee events every weekend year round and I do enjoy my...
|
|
Forum: Mopar
06-18-2024, 09:23 PM
|
|
Replies: 14
Views: 2,893
Well, I've been hard at work on this Truck for...
Well, I've been hard at work on this Truck for the past few months. I'll add posts as I get time to show the progress. I was able to fix all of the oil leaks, replaced the timing set, cleaned the...
|
|
Forum: Supercar/Musclecar Discussion
06-18-2024, 05:38 PM
|
|
Replies: 10
Views: 868
|
|
Forum: Supercars/Musclecars-For Sale
06-18-2024, 05:33 PM
|
|
Replies: 1
Views: 394
1968 L88 Corvette Convertible - Silverstone Silver
https://www.corvettemikeanaheim.com/vdp/21328399/Used-1968-Chevrolet-Corvette-1968-SILVERSTONE-SILVER-CORVETTE-L88-CONVERTIBLE-for-sale-in-Anaheim-CA-92807
1968 Chevrolet Corvette 1968 SILVERSTONE...
|
|
Forum: Pay it Forward Classifieds
06-18-2024, 05:20 PM
|
|
Replies: 0
Views: 181
Free (pay shipping)
I found some issues of Super Chevy Club that someone might find them interesting. I could only find five issues but I found the pin, the decal and a few things.
This is offered to anyone who...
|
|
Forum: Baldwin-Motion Performance
06-18-2024, 02:58 PM
|
|
Replies: 2
Views: 227
|
|
Forum: Supercar/Musclecar Discussion
06-18-2024, 12:10 AM
|
|
Replies: 1,104
Views: 1,676,428
|
|
Forum: Supercar/Musclecar Discussion
06-17-2024, 11:52 PM
|
|
Replies: 1,104
Views: 1,676,428
|
|
Forum: Supercar/Musclecar Discussion
06-15-2024, 09:01 PM
|
|
Replies: 1,104
Views: 1,676,428
|
|
Forum: Day 2 stuff-modified cars
06-15-2024, 06:57 PM
|
|
Replies: 147
Views: 95,223
|
|
Forum: Supercar/Musclecar Discussion
06-15-2024, 06:54 PM
|
|
Replies: 1,104
Views: 1,676,428
|
|
Forum: Supercar/Musclecar Discussion
06-14-2024, 10:38 PM
|
|
Replies: 7
Views: 901
Jl8 z28
Attached are two photos of the Hugger Orange Z/28 after I finished the restoration in 1981. The car did not have a crossram setup when I purchased it or a GM fiberglass hood. I acquired these items...
|
|
Forum: Supercar/Musclecar Discussion
06-14-2024, 07:04 PM
|
|
Replies: 11
Views: 887
|
|
Forum: Lounge
06-13-2024, 02:49 PM
|
|
Replies: 5
Views: 536
|
|
Forum: Lounge
06-13-2024, 02:33 PM
|
|
Replies: 5
Views: 536
|
|
Forum: Member's Rides
06-13-2024, 01:29 AM
|
|
Replies: 142
Views: 52,950
Fixing Speaker Mounts in the Deck
Seems like just about every car I restore someone has butchered the speaker holes. Pretty easy fix. Always nice using original metal as it fits into place with no massaging or mismatching of holes...
|
|
Forum: Member's Rides
06-13-2024, 01:26 AM
|
|
Replies: 142
Views: 52,950
300 Deluxe Rubber Floor Question?
I was curious if anyone could provide some explination about a few things related to the 300 deluxe cars. Upon getting into the car I noticed that there were small twisted shank nails pounded into...
|
|
Forum: L78/L89 specific Forum
06-12-2024, 11:54 PM
|
|
Replies: 355
Views: 171,972
I've wanted this look since my last project. In...
I've wanted this look since my last project. In fact I bought these wheels for my Red 67 project a few years ago. I'm really happy how this looks! 15x10 steelies dated 1973. 4.5" Backspace wearing...
|
|
Forum: Garages/shops..
06-12-2024, 03:23 PM
|
|
Replies: 8
Views: 781
|
|
Forum: AMC
06-12-2024, 12:48 AM
|
|
Replies: 39
Views: 8,253
Little update
Got the car all put back...
Little update
Got the car all put back together. New axle bearings and seals, fresh oil and added posi additive this time. Car drives much nicer so I’m assuming those bearings were junk from the...
|
