I am officially inspired. Going to work on the Corvette!
|
We have had a VERY rainy Spring/Summer so far and I finally got the car outside 2 days ago, to get epoxy sealer/primer on the raw dash/instrument panel. Had a few peeks of sun thru the clouds and it was windier than I would have liked, but ya gotta get stuff done when ya can....
Now to get all the seams sealed up. https://www.yenko.net/forum/cache.ph...ACE21MzMUJ.JPG https://www.yenko.net/forum/cache.ph...HCVASyZrMb.JPG https://www.yenko.net/forum/cache.ph...ieKJoUoD4A.JPG https://www.yenko.net/forum/cache.ph...zJrMEp4zBS.JPG https://www.yenko.net/forum/cache.ph...zZfUxLsjvW.JPG . |
Looking great. How did you weld the dash panel at the base of the windshield - were those plug welds or spot welds?
|
Most of it I did with the spot welder, you can see the dimples. The left wiper transmission mount prevented me from getting beyond it and there are about 8 plug welds on that side and I think 3-4 on the far right as well.
|
All times are GMT. The time now is 02:27 PM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.