Bits and Pieces
Looking for some small stuff for my '69 Chevelle if anyone can help?
Correct throttle bracket 396 w/ Quadrajet #3992376 Q Jet carb stud & wing nut 1/4" & 3/8" pinch clamps Filter bracket Correct PCV hose TIA |
I should have the pinch clamps how many do you need
|
If you let me know length and configuration on the Quadrajet carb stud I probably have it. And I definitely have the Wingnut
|
The pcv hose can be ordered from Doc Rebuild, The Corvette guy. Ribbed & curved...Joe
|
Quote:
I will take 6 of each if you have them? |
Quote:
|
Damien,
Looking Great! You also need a Cowl Seal and the correct metal clips....and those plastic Cowl Covers were never on any 1969 Chevelle. Also run your orange heater blower wire on the Bottom side of your heater. It’s coming along nicely. Keep up the great improvements. Dan |
Thanks Dan.
It had a rubber cowl seal on it but I took it off. Pushes the rear of the hood up. It needs a foam seal. |
Quote:
My hunch is that the former car owner purchased a reproduction Cowl Seal from Ground Up, Inc. I know this because the former owner worked part time for Ground Up. Or you may have an early style reproduction hood which has now been redesigned better. Their early reproduction hoods were notorious for sticking up in the back. What you need is an original Cowl Seal :) Dan |
Dan,
Original seal, as in NOS? Or original as in design? Carb stud and wing nut sorted. The big things for me are the throttle bracket and filter clamp. |
All times are GMT. The time now is 06:28 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.