The Supercar Registry - from a 12" flexplate to a 14"

The Supercar Registry (https://www.yenko.net/forum/index.php)

- Technical & Restoration (https://www.yenko.net/forum/forumdisplay.php?f=86)

- - from a 12" flexplate to a 14" (https://www.yenko.net/forum/showthread.php?t=156159)

dmarr35

07-22-2019 07:57 PM

from a 12" flexplate to a 14"

I have a 1969 427 with a th400 it had a 12" 3 lug converter I want to change t a 6 lug 14" flexplate can I do this and if so what about the starter? Thank You

dmarr35

07-22-2019 08:38 PM

I think I just have to go to a staggered bolt starter

John Brown

07-23-2019 12:10 AM

Yes. Common aluminum snout starter is industry number 3510, industry number for iron snout starter is 3689.

John Brown

07-23-2019 12:29 AM

And.... when you buy your new starter, may as well buy the correct bolts to mount it with. No reason to cheap out now. :)

dmarr35

07-23-2019 10:04 AM

Thank You

earntaz

07-23-2019 12:52 PM

Quote:

Originally Posted by John Brown (Post 1456300)

And.... when you buy your new starter, may as well buy the correct bolts to mount it with. No reason to cheap out now. :)

So true -- you're not going to believe how many times I have seen Pick-a-Nut bolts used to bolt on starters and the owner can't figure out where all the racket comes from along with tore up ring gear ... TAZ

All times are GMT. The time now is 08:43 PM.

O Garage vBulletin Plugins by Drive Thru Online, Inc.