TCS Rivets/Tool for firewall gutter
Does anyone know if the rivets and tool are still available in this old thread? I tried sending a message a few days ago through this site, but just checked, and it apparently didn't go through. The Nova Research email has also been disabled according to that site. Thanks
https://www.yenko.net/forum/showthre...t=relay+rivets |
1 Attachment(s)
|
|
1 Attachment(s)
In case you want to "roll your own"
Made mine on a CNC mill using an old transfer punch, but a lathe may work. The rivets I got from my local TrueValue hardware store in the Hillman stuff: https://shop.hillmangroup.com/ccrz__...78&cclcl=en_US |
1 Attachment(s)
I made a tubular rivet tool out of an old punch on a lathe too. I also made a fitting to go in this rivet tool to get to areas where a punch was too big and you couldn't use a hammer to peen over the rivet.
|
|
Thanks for the info guys
|
All times are GMT. The time now is 01:59 AM. |
Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.