SBC 461 Heads
 

I am in need of a set of 461 SBC heads dated late August to early September of 62. Non ported straight up castings preferred.

Thanks,

Tim

(262) 844-5218
[email protected]

Re: SBC 461 Heads
 

What valve sizes?

Screw in or pressed studs?

Bare castings or ready to install?

Re: SBC 461 Heads
 

All 461X heads were pressed in studs and 1.94 valves. In 1963, 340 and 360 fuelie versions got swirl polished valves but the valve sizes still stayed 1.94.

Re: SBC 461 Heads
 

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: Fast67VelleN2O</div><div class="ubbcode-body">All 461X heads were pressed in studs and 1.94 valves. In 1963, 340 and 360 fuelie versions got swirl polished valves but the valve sizes still stayed 1.94. </div></div>

Yea, what he said! As far as condition, I will consider bare castings, good cores, and finished heads. Just looking for good heads that have not been messed up with the date range I detailed in my post. The heads are the last of what I need to button up the engine for my fuelie.

Thanks,

Tim

Re: SBC 461 Heads
 

Sorry for all the ?'s, I might be able to help, just trying to cover the bases before I make any calls.

Re: SBC 461 Heads
 

I have a mint untouched pair of X heads (bare) but they are too early for you. Good luck on the search. They are getting hard to find.

Re: SBC 461 Heads
 

All I could come up with was late September dates.

Sorry I couldn't help.

Re: SBC 461 Heads
 

Thanks everyone. I am still looking. A fellow on Corvette Forum says he may have a set of early September heads. Until then.................

Thanks,

Tim

Re: SBC 461 Heads
 

Still looking................

Re: SBC 461 Heads
 

Didn't Joe Smith have a set at MCACN - maybe the dates were too late?

Jake