Hurst Ram Rod in a 67 Nova
 

As a result of my clutch failure and lack of admiration for my TKO 600, I am giving thought to an Auto Gear M22. If I went that direction, has anyone used a Ram Rod (or Vertigate) in a 66 /67 Nova with a bench seat?

Thanks,

Tim

Re: Hurst Ram Rod in a 67 Nova
 

Not sure about the Ramrod but the Mr Gasket vertical gates normally sit back a little further than a normal shifter.. I would think this style shifter will not work with your bench seat especially with the reverse lever jutting out the back.

Re: Hurst Ram Rod in a 67 Nova
 

Back in the 80's my buddy had a hurst super shifter three in his 67 with a bench seat and that shifter sits in the same spot as a ramrod but you will have to cut your tunnel up a lot to fit the straight rods.

Re: Hurst Ram Rod in a 67 Nova
 

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: mr.4speed</div><div class="ubbcode-body">Back in the 80's my buddy had a hurst super shifter three in his 67 with a bench seat and that shifter sits in the same spot as a ramrod but you will have to cut your tunnel up a lot to fit the straight rods.
</div></div>
It's already cut up for the Tremec. Good to hear!

Re: Hurst Ram Rod in a 67 Nova
 

The Ramrod shifter is way more compact than the Vertigate. On the one I installed for the Vega, I used a standard set of shift rods and modified them to &quot;hug&quot; the transmission. There was no need for heavy cutting of the trans tunnel.

Re: Hurst Ram Rod in a 67 Nova
 

I have a 66 Chevy II 327 350hp ZI ,12 bolt 3.73 ,lakewood bell housing ,Muncie m21 with a super shifter and the tunnel needed some mods to make work but is nice to take out and bang some gears in....