Valve Cover ID??
 

Can somebody identify the application for these? They have drippers.

https://www.yenko.net/ubbthreads/pics...1-p1050215.jpg

Re: Valve Cover ID??
 

On the left side or drivers side are there 2 wire clips on top, I cannot see in the pic? It looks like 69 Chevelle but it is missing the sending unit wire clip on the bottom. The pass side is 69 from the position of the short plug wire stand in line with the breather hole

Re: Valve Cover ID??
 

<div class="ubbcode-block"><div class="ubbcode-header">Originally Posted By: 69L78</div><div class="ubbcode-body">On the left side or drivers side are there 2 wire clips on top, I cannot see in the pic? It looks like 69 Chevelle but it is missing the sending unit wire clip on the bottom. The pass side is 69 from the position of the short plug wire stand in line with the breather hole </div></div>



Unless it has the clips on the intake side of the drivers cover for the sending unit going to the intake and assuming the harness was similar as Camaro for the sending unit these would be for a 68 Chevelle as the sending unit wire ran with the alt wiring.

Re: Valve Cover ID??
 

I would say they came off a 1967 or earlier since it has a breather cap instead of a vent tube to the air cleaner. The breather cap looks to be original.

Re: Valve Cover ID??
 

Also -- there is not &quot;dent&quot; in the rear drivers side to clear the booster? ... but I think that came much later ... TAZ

Re: Valve Cover ID??
 

that is not a 67 valve cover with that breather cap, the short wire stand is in line with the breather. 67 covers had the short wire stand in between the breather and the oil fill hole

Re: Valve Cover ID??
 

Some info that may help:
http://www.camaros.org/engine.shtml#bbcover