Motion sidepipes?
 

Hello all, I am just found this sight, and imagine some one here can answer my question. Does anyone know where I could get a set of side pipes like the ones on the phase three cars? I would like to put a set on my nova. Any info on what kind Joel used would be great. Thanks

Re: Motion sidepipes?
 

On the early cars, Joel used the midyear ('65-'67)corvette side exhaust. These are still readily available from any corvette supplier at about $2,000 for the complete set-up.

Re: Motion sidepipes?
 

Thanks so much for the info, I really do appreciate it!

Re: Motion sidepipes?
 

On the later cars he used the chrome Hooker 4 into 1 pipes. The big block ones for a Camaro & Nova are no longer made by Hooker still makes the small block ones
Dave

Re: Motion sidepipes?
 

can anybody recommend a place to buy the "correct" style/preferred shape big block headers for a '69 camaro that fit with the mid sixties corvette style sidepipes.....tanx

Re: Motion sidepipes?
 

For the 1st gen. Camaros, Motion typically used standard Hooker headers and then fabricated an "S" pipe to tie into the mid-year corvette side exhaust. There is an article in a '69 CARS magazine which shows this. Another method used was to tap into the side of the header at the point just beyond where the 4 tubes came together and then fabricate a pipe to tie into the side exhaust. A plate was used to block off the header outlet which could be removed at the track for open headers. This set-up was also shown in CARS magazine. I have never seen a header made for 67-69 Camaros to tie into the corvette side exhausts. Hedman made headers for the corvette that hooked up to the side exhaust, but this would not work on Camaros.

Re: Motion sidepipes?
 

Maybe its the same magazine ,but I also remember an article from 1967/68 detailing the side pipe installation on a Nickey 427 Camaro, just as you refered to.