The Supercar Registry

The Supercar Registry (https://www.yenko.net/forum/index.php)
-   Technical & Restoration (https://www.yenko.net/forum/forumdisplay.php?f=86)
-   -   Chevy TH400 Transmission #s question (https://www.yenko.net/forum/showthread.php?t=77333)

TOYVET 06-02-2004 01:28 AM

Chevy TH400 Transmission #s question
 
Wanted to check w/ the board...is the car's VIN stamped on 1969 Chevy TH400 transmissions for Corvettes, Camaros, etc...
Thanks

JChlupsa 06-02-2004 01:35 AM

Re: Chevy TH400 Transmission #s question
 
Cant get any better than this for detail:

From the Camaro Research Group Web Site

http://www.camaros.org/numbers.shtml...missionNumbers

GTO_DON 06-02-2004 03:09 AM

Re: Chevy TH400 Transmission #s question
 
yes it is!! its up around the end of the bellhousing on the passenger side.......look hard!! https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Mr70 06-02-2004 03:20 AM

Re: Chevy TH400 Transmission #s question
 
I've seen the VIN# stamped into the TH400 on the Driver side into a 3 inch recessed machined Horizontal pad above the Pan gasket,just behind the shift linkage bracket & boot.
Or also look up around the Driver side Bellhousing mating area too.

lowmile 06-02-2004 04:10 PM

Re: Chevy TH400 Transmission #s question
 
1 Attachment(s)
Like this?? I still haven't been able to decode these numbers.

Mr70 06-02-2004 05:08 PM

Re: Chevy TH400 Transmission #s question
 
Mark,EXACTLY what I meant.Good Picture! https://www.yenko.net/ubbthreads/imag...iggthumpup.gif
That is a perfect example of a Replacement Transmission Code,similar to a CE Engine block code.

H9T 05030 breaks down as:
H=Hyra-Matic
9=model year,1969
T=Transmission
05030=Unit Sequence number produced.
The Cleveland plant started producing at 00001 and went up to 14999,so we know it was from the Cleveland Plant.
What does the passenger side Aluminum Rectangular tag show?
Rick


lowmile 06-02-2004 07:46 PM

Re: Chevy TH400 Transmission #s question
 
1 Attachment(s)
There isn't a tag on the passenger side. If you look in the hole where the tag rivit should go, it looks like there never was one on it. The story I got from the owner at the time was, the drive shaft got thrown out in 1970 and it wrecked the original tranny. thanks for the info! https://www.yenko.net/ubbthreads/imag...ns/scholar.gif m

Mr70 06-02-2004 09:04 PM

Re: Chevy TH400 Transmission #s question
 
That's Typical of what I have seen & heard of Service replacement Transmissions.
There were 4 Transmission plants making these,and for the following Car Manufacturers:
Buick-Olds-Pontiac-Chevrolet-Cadillac.They didn't use a Pass. side suffix tag,because they didn't know what application that trans. would be used for.
Your findings help back that up.
I Thank You. https://www.yenko.net/ubbthreads/imag...iggthumpup.gif
Rick


All times are GMT. The time now is 08:41 AM.

Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2025, vBulletin Solutions Inc.


O Garage vBulletin Plugins by Drive Thru Online, Inc.