Block assembly date
 

Is it possible for an engine to have an assembly date, the same as the casting date.

Thanks,


Jason

Re: Block assembly date
 

Yes I have 66-396 325 iv cast the same date as stamped.

Re: Block assembly date
 

Someone explain how that is possible...didn't the blocks have to season a bit before they were machined ? Damn thing would still be hot.....

Re: Block assembly date
 

Not to mention, are engines cast and assembled in the same place? Probably a stupid question, but seems as though the foundry for casting would be in a different place.

Re: Block assembly date
 

With three shifts running at that time you would have 48hrs to do the work. I don't know it blew me away too when I seen it.

Re: Block assembly date
 

Well, I have to say.. my gut answer would have been DOUBTFUL if at all possible.. but obviously at least two members here have one like this, so I guess once again... anything is possible. My reply would now be VERY RARE but possible.

Could I see photos of this by any chance?

Mike

Re: Block assembly date
 

I remember a Local 454 Monte Carlo & Chevelle over here that have the same dates,Casting & Tonawanda.
Like Mike stated,it's very rare,but I believe it to be possible.

What happened to elcaminos reply?

Re: Block assembly date
 

I have 40+ BBlocks in my garage and that part is not heated!! Will take pictures when it warms up. It will take some time to find it. https://www.yenko.net/ubbthreads/imag...mlins/haha.gif https://www.yenko.net/ubbthreads/imag...lins/beers.gif

Re: Block assembly date
 

I just can't believe a block would be cast and a complete engine built from it on the same day. Did they cast the date maybe a day ahead of time so when it came out of the mold it would have that day on it? Or did the guys doing the stamping forget to change the date in the stamp?

Re: Block assembly date
 

Kim,

While your in the garage, check to see if you have MY block will ya!!! 8L341778. 396/375...

Thanks
Ed