Holley carb power valve questions
 

I'm rebuilding a Holley 4557 for my 70 L78 Camaro. It looks like it had a 10.5 primary and an 8.5 secondayr power valve. The rebuild kit looks like it has a pair 6.5 valves? Is that too low to go compared to stock? This carb is really old and has been sitting for years so I'm doing a cleaning and rebuild and can't compare before and after. I'm thinking I need to stick with someting closer to stock instead of the 6.5's that are in the kit.

Re: Holley carb power valve questions
 

I'm running the same power valve numbers 10.5/pri--8.5/sec on a 3310 that I use on and off and the car responds real good and idles well with no surging--Bring your engine to operating temp and take a vac.reading and then step down 2 numbers....to start.

Re: Holley carb power valve questions
 

Our L72 engine came with 6.5 poweR valves front and back.

Re: Holley carb power valve questions
 

Jeff;

The original power valves for a 4557 are 8.5's both front & rear. If your engine is stock, I'd stick to that.

Eric

Re: Holley carb power valve questions
 

The engine has 2" primary headers, HEI distributor, I think they're 1971 oval port heads(to lower compression), stock flat L78 intake and I'm going to assume stock cam. If I remember correctly, when I checked the compression and vacuum it was reading around 13 at idle. So I'm thinking the 6.5's will be too low. I would rather get the power valves right the first try so I'm in no hurry. Thanks guys.

Re: Holley carb power valve questions
 

Jeff;

Check your PM's.

Eric

Re: Holley carb power valve questions
 

We run a 65 in the front and a plug in the rear of ours...seems to work... https://www.yenko.net/ubbthreads/imag...ns/naughty.gif

Re: Holley carb power valve questions
 

[ QUOTE ]
We run a 65 in the front and a plug in the rear of ours...seems to work... https://www.yenko.net/ubbthreads/imag...ns/naughty.gif

[/ QUOTE ]

Ditto that setup on the Deuce https://www.yenko.net/ubbthreads/imag...ns/naughty.gif

Re: Holley carb power valve questions
 

Just curious..Are you both using the 6.5 PV with the window openings...........

Re: Holley carb power valve questions
 

They're just plain old off the shelf pv's, but "yes", I believe they do indeed have the windows...