Cowl plenum breather
 

Has anyone seen the new cowl plenum breathers from NKR products. bought a 68 Z with the cutout for a cowl plenum breather but the original plenum is long gone. Any help would be great

Re: Cowl plenum breather
 

Did you get the blue car? I remember somebody sells one out of the S.F. bay area or northern California. Maybe by the name of T/A performance or a name close to that. I think he advertises in Hemmings.
Mark Sheppard

Re: Cowl plenum breather
 

Is it fiberglass??steel?? I would not fill the hole. Just make a cowl plenum "delete" plate until you have the funds to buy an air cleaner. That setup is just too coollll!!!

Re: Cowl plenum breather
 

It is a blue car but a Canadian car . The plenum breathers are suppose to be steel and not fibreglass like Taperfesto

Re: Cowl plenum breather
 

They sell repops here:

http://taperfresto.com/cowl_plenum_a_c.html

Re: Cowl plenum breather
 

-----I have one of those C/I air-cleaners. Im putting it on my station wagon!!!!!........Bill S

Re: Cowl plenum breather
 

I have used a few of the TA performance air cleaners and other than touching it they look like metal.

Re: Cowl plenum breather
 

Google NKR Products and you can see the plenums I am speaking of. Anyone know of them/

Re: Cowl plenum breather
 

Paul, Did you get the Canadian documentation for the car yet? If so did it show the cowl plenum being ordered with the car? Go for broke, get a crossram and a factory cowl plenum air cleaner set up. Am I reading this right that the whole air cleaner is made out of plastic? I had a 1967 Z/28 and I remember that the duct that attaches to the firewall was plastic with a rubber tube that fed into a steel air cleaner. This was over 20 years ago, was I looking at a reproduction?
Mark Sheppard
Mark Sheppard

Re: Cowl plenum breather
 

From what I have heard the cowl plenums from NKR are very close... the lid is the only minor difference... I have read that unless you have the lids side by side you can't tell them apart.