Go Back   The Supercar Registry > Search Forums


Showing results 1 to 25 of 500
Search took 0.02 seconds.
Search: Posts Made By: Too Many Projects
Forum: Ebay & other seen ads section Yesterday, 12:19 PM
Replies: 1
Views: 219
Posted By Too Many Projects
I drove a few of them "back in the day" and the...

I drove a few of them "back in the day" and the HO, quadrajet 4V, was spunky for a 6 cylinder, but this one barrel version isn't going to leave much of an impression.
Forum: Chevrolet Yesterday, 03:43 AM
Replies: 11
Views: 668
Posted By Too Many Projects
My '67 ss/rs was hit fairly hard in the right...

My '67 ss/rs was hit fairly hard in the right rear early in it's life and a quarter skin brazed on, partly over the old one. The trunk floor was still all wavy and the tail panel had been sectioned...
Forum: Pay it Forward Classifieds Yesterday, 12:58 AM
Replies: 4
Views: 226
Posted By Too Many Projects
Send me your address in a PM and I'll get a...

Send me your address in a PM and I'll get a shipping cost for you.
Forum: Chevrolet Yesterday, 12:47 AM
Replies: 11
Views: 668
Posted By Too Many Projects
First thing this morning, I removed the rear...

First thing this morning, I removed the rear window trim and went to cut the butyl seal with a hand cutter. Hmmm....when did the factory go to urethane ? That "stuff" is waaay harder to cut. Took me...
Forum: Lounge 06-16-2021, 01:08 PM
Replies: 21,891
Views: 2,200,841
Posted By Too Many Projects
Yikes, that doesn't look like it ended well. How...

Yikes, that doesn't look like it ended well. How the heck did they get it back on firmer ground ?
Forum: Lounge 06-16-2021, 01:04 PM
Replies: 21,891
Views: 2,200,841
Posted By Too Many Projects
I was just there a few weeks ago with the...

I was just there a few weeks ago with the Chevelle club. They are celebrating 60 YEARS in the same location this summer. If you are local, stop in and support them. Damn few drive ins left.
Forum: Pay it Forward Classifieds 06-16-2021, 02:48 AM
Replies: 4
Views: 226
Posted By Too Many Projects
New price...FREE, just pay shipping.

New price...FREE, just pay shipping.
Forum: Chevrolet 06-16-2021, 01:22 AM
Replies: 11
Views: 668
Posted By Too Many Projects
Not much changed visually today. LOTS of time...

Not much changed visually today. LOTS of time spent removing spot welds. I started drilling them, but I don't like the tip on the drills they have at work. By the time the top layer is drilled...
Forum: Supercar/Musclecar Discussion 06-15-2021, 10:27 PM
Replies: 31
Views: 4,982
Posted By Too Many Projects
I love it when that happens. I've bought a couple...

I love it when that happens. I've bought a couple of "basket cases" with, supposedly bad engines, and gotten them running and driving with a bit of work...:biggthumpup:
Forum: Supercar/Musclecar Discussion 06-15-2021, 10:23 PM
Replies: 7
Views: 849
Posted By Too Many Projects
The 2 single seaters are ultra lights. The prop...

The 2 single seaters are ultra lights. The prop is a pusher and there would be a large wing above the mounted on the mast.
Forum: Technical & Restoration 06-15-2021, 12:46 PM
Replies: 17
Views: 893
Posted By Too Many Projects
You state that the points always look new when...

You state that the points always look new when the failure happens. Using a full 12 volt wire would badly pit the points. You can verify the original low voltage wire by the woven fabric on it at the...
Forum: Chevrolet 06-15-2021, 01:41 AM
Replies: 11
Views: 668
Posted By Too Many Projects
Here we go, rip, tear and dissect. I welded a...

Here we go, rip, tear and dissect. I welded a pulling tab on the bumper and pulled that out far enough to gain access to the mounting bolts and remove it. The quarter started unfolding with it.
...
Forum: Lounge 06-14-2021, 12:52 AM
Replies: 21,891
Views: 2,200,841
Posted By Too Many Projects
I bought one of those kits from a guy on another...

I bought one of those kits from a guy on another forum a few years ago. He MAY have bought it new, but was moving and purging stuff he'd held onto for 30-40 years. Still sealed in the bags.

...
Forum: Technical & Restoration 06-12-2021, 09:10 PM
Replies: 17
Views: 893
Posted By Too Many Projects
Check them at 200 miles and reset, if necessary....

Check them at 200 miles and reset, if necessary. You most likely know, but, more is less, meaning the higher the dwell, the narrower the gap. I always set new points at 28 and they stay within the 4...
Forum: Technical & Restoration 06-12-2021, 09:08 PM
Replies: 17
Views: 893
Posted By Too Many Projects
Pertronix does make a cast aluminum body look...

Pertronix does make a cast aluminum body look alike to the original distributors with their electronic triggers inside. They do require the matching coil, and I don't recall if the distributor is the...
Forum: Technical & Restoration 06-12-2021, 02:39 PM
Replies: 17
Views: 893
Posted By Too Many Projects
Did you check the dwell when the issues started,...

Did you check the dwell when the issues started, before removing the points ? I found, years ago, the rubbing block does seem to wear in about that 300 mile mark and the points close up enough to...
Forum: Lounge 06-12-2021, 12:30 AM
Replies: 33
Views: 1,628
Posted By Too Many Projects
The number of homicides and shootings in Chicago...

The number of homicides and shootings in Chicago spiked dramatically in 2020, ending with more bloodshed than in all but one year in more than two decades, statistics released by police on Friday...
Forum: Chevrolet 06-11-2021, 10:17 PM
Replies: 11
Views: 668
Posted By Too Many Projects
1971 Chevelle repair

Some of you saw the pics I posted of a friends '71 Chevelle I was looking for parts for.
...
Forum: Lounge 06-11-2021, 03:25 AM
Replies: 43
Views: 1,790
Posted By Too Many Projects
Well, that makes sense...a Sunliner in sunny...

Well, that makes sense...a Sunliner in sunny AZ...:flag:
Forum: Ebay & other seen ads section 06-11-2021, 03:21 AM
Replies: 4
Views: 583
Posted By Too Many Projects
Yeah, Farmington has a LOT more trees for shade. ...

Yeah, Farmington has a LOT more trees for shade.
Glad to hear you did well.
I skipped the meet Sunday. Nothing in particular I needed/wanted and I had other stuff to do before it got too danged hot...
Forum: Ebay & other seen ads section 06-10-2021, 09:27 PM
Replies: 10
Views: 730
Posted By Too Many Projects
Has anyone made an offer of 25k yet ? Might the...

Has anyone made an offer of 25k yet ? Might the OBO for that "thing".
Forum: Parts/Memorabilia - Wanted 06-10-2021, 12:46 PM
Replies: 42
Views: 4,268
Posted By Too Many Projects
Yep, when he quoted me $120 for an NOS tail panel...

Yep, when he quoted me $120 for an NOS tail panel that sells for $700, I knew it was a scam.
Hell, $120 for an NOS part ?? Sign me up for a dozen...:wink:


Glad you didn't get taken.
Forum: Ebay & other seen ads section 06-10-2021, 12:10 PM
Replies: 4
Views: 583
Posted By Too Many Projects
How did you do at the swap meet ? Survive the...

How did you do at the swap meet ? Survive the heat OK ? Damn it was hot for that show.
Forum: Lounge 06-09-2021, 07:44 PM
Replies: 5
Views: 444
Posted By Too Many Projects
New member Nicolamoore has been busy drumming up...

New member Nicolamoore has been busy drumming up work for Mike Phelps.
There's at least 4 of us now that have been contacted.
Forum: Parts/Memorabilia - Wanted 06-09-2021, 07:41 PM
Replies: 42
Views: 4,268
Posted By Too Many Projects
"Mike" just sent me pics of an aftermarket tail...

"Mike" just sent me pics of an aftermarket tail panel...:grin:
Showing results 1 to 25 of 500

 
Forum Jump

All times are GMT. The time now is 02:24 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2021, vBulletin Solutions Inc.