[kwhizz]

The next step in the conversion is to replace the stock Master Cylinder with a Matched Disc/Drum Power Master cylinder assy...............Had to elongate the holes on the booster adaptor to get them to fit over the factory studs on the firewall......(you would think the aftermarket guys would have that pattern figured out by now).........I also had to remount the Proportioning valve as there were some clearance issues.......I also had to make some new Brake lines and got to use the "Best" Tool in the garage again.......The Eastwood Flaring tool.....After fighting with those Chinese Crap Flaring tools while building the Chevelle and buying a Real tool............What a delight.......No stress......Just flare in 10 seconds.....every flare is perfect..........one more line to run and the Engine/Trans go's in for good (hopefully)......