The ones NPD sells are made by TWE and are very accurate looking, except the long bolts that come with them are not correct (but those can be bought from AMK). Don't overtighten them though, as the top side rubbers will "roll" over the washer and pop off if the bolt is too tight. I guess they should be made of a little stiffer material?
The ones on Ausley's website look the same, but I don't know if they are from the same mfr.
The ones Inline Tube sells also look correct, and have a closer to correct bolt. But again I don't know if those are being made by Inline or by TWE or by someone else.
Good luck!
__________________
Jeff Helms
65 Z16 Survivor
65 Z16 drag car
66 Chevelle L78 unrestored
67 Chevelle L78 unrestored
67 Camaro SS350 Survivor
|