[KevinW]

Here is a factory original 39535227 pitman arm for power steering boxes, came on Z/28's and SS models in 69. This has been cleaned and put in Evaporust. A little new grease has been pumped in to displace the old, but still some old grease still in there. Grease fitting is not original. Molded seal (close up pic from another arm) is MISSING. Shaft spins free, without any side to side looseness. There is some stubborn gray and red oxide paint on arm.
it will need paint stripping or glass beading to remove. Has a small bit of hammer damage to edges. Original castle nut will be included (after its clean)
$250, shipping included to lower 48. Paypal preferred