View Single Post
  #14  
Old 12-21-2024, 05:18 PM
turbo69bird's Avatar
turbo69bird turbo69bird is offline
Senior Member
 
Join Date: Sep 2005
Location: Here
Posts: 323
Thanks: 104
Thanked 644 Times in 158 Posts
Default

That trans case had been dipped and they couldn’t get the black specs out of it no matter what they did. It took a lot of work but I was able to get it right w the Vapor blaster

Took me about 5 hours to get it right certainly wasn’t a money maker by any means.
In fact IMO vapor blasting isn’t a fast low labor solution. Takes a long time and a lot work to get it right. There’s alot of angles and I’m constantly pulling the part out washing it, inspecting it and putting it back in to get it right

I don’t want to do any more to a part than I need to, but I also don’t want it unfinished. You just can’t tell while it’s in being done.

Idk how anyone could ever make money doing vapor blasting for a living.
Reply With Quote
The Following User Says Thank You to turbo69bird For This Useful Post:
Lynn (12-21-2024)