[njsteve]

Being the tinkerer that I am, I decided that the finish on the rubber rim was a little too flat so I used a can of the black Plasti-Dip Rubber Coating Spray and sprayed several coats on the rim. That stuff is amazing. It leaves a nice rubbery semi-shiny finish on the surface that duplicates the original foam rubber finish perfectly, and I had no problems with spraying the coats immediately after one another even though the can says wait 30 minutes between coats. I think they mean if you stop spraying, and let it sit for more than a minute, it may craze the previous layer. So, I ended up just spraying continuously to fully cover all surfaces of the rim. I then just left it to sit overnight. Here is the result from this morning.