[dwright406]

I've got a nice set of 186 casting camel hump heads I've decided to sell.
These heads have about 200 miles on them since rebuilt. They had:
New stainless swirl flow valves, 1.94's & 1.50's,
New Bronze Guides,
New Hardened Seats,
Fresh 3 angle valve job,
New Z28 Springs good to .550 lift,
Tapped for screw in studs, but I robbed the studs off of them for my new heads.
Haven't been ported heavily, just deburred & gasket matched.
I put $200+ in parts & $300 worth of machine work into them, put about 200 miles on them, then the engine spun a bearing. Heads are still like new save for a little carbon.

Like to get $450 for them