Thread: trunk spatter
View Single Post
  #5  
Old 06-09-2019, 12:25 PM
DaveC68's Avatar
DaveC68 DaveC68 is offline
Yenko Contributing Member
 
Join Date: Oct 2003
Location: Southern NJ
Posts: 313
Thanks: 34
Thanked 11 Times in 4 Posts
Default

an Earlier thread;

https://www.yenko.net/forum/showthread.php?t=120533


I have used The Parts Place black/aqua a few times sprayed out of Devilbiss Finish line gun with 1.8 tip ( no strainer or screen in cup/gun of course) with good results.
Although the very first time was sent a can that had either been frozen or frozen in shipping, it performed terribly, which they replaced.
Most recently picked up a can from Ausley's at spring Carlisle.
not sure what happened but the spatters in the can were already small, and sprayed out small through a primer gun with 2.0 tip. Looks no better than hobby store faux granite finish or the water soluble automotive stuff that comes in a buzz-bomb. I contacted The Parts Place to inquire if supplier or product had recently changed and got nowhere....pretty disinterested in my experience, not sure I'll get anywhere with Ausley's either. But I would still use this product over any other.
__________________
Dave C.
68 SS396 Camaro
69 SS396 CB Chevelle Conv.
70 340 Dart Swinger
70 SS396 Chevelle 4spd
70 SS396 Chevelle
70 BB 4spd Monte Carlo
70 SS454 Monte Carlo
71 SB 4spd Monte Carlo
71 SS454 Monte Carlo
71 Corvette LS-5 conv.
71 Corvette LT-1 conv.
71 Corvette LS-6 coupe
72 Monte Carlo
72 Monte Carlo Custom
72 442 W-30 clone
76 Trans Am SE 455 4 spd
85 Mustang GT Conv.
86 Grand National
02 SS conv.

Last edited by DaveC68; 06-09-2019 at 12:31 PM.
Reply With Quote