View Single Post
  #23  
Old 12-05-2017, 07:42 PM
KenMaisano's Avatar
KenMaisano KenMaisano is offline
Senior Member
 
Join Date: Jun 2013
Location: So .Cal.
Posts: 446
Thanks: 0
Thanked 165 Times in 81 Posts
Default

but the block is over there in the corner with a 'How to build Ford FEs' engine book on top of it!"

Couples small things. If your installing hard EX seats only go down about .200 deep. Cam bearing holes go in at 3Pm position. Test oil pump drive with distributor installed, make sure, with thrust plate and timing gear installed all lifters spin, many core shift problems. Crower cam saver lifters work well and only loose 5 psi of oil pressure.
Reply With Quote