Quote:
Originally Posted by NorCam
A few suggestions on a new shop:
Pre-wire the shop and if running power from the house where you're trenching to the new shop, bury a separate conduit or direct burial date cable to tie in the comms and internet from the house to the new shop if it doesn't have stand along power and telco points for comms and internet. This will allow you to tie the shop security into the main house and have it controlled as a separate partition.
Cable the shop with a head end location and 110V power allocated for an alarm panel. From that point, run 22/4 quad cabling to all alarm points such as the keypad, headers of the man doors and the overhead doors for alarm contacts to be installed. Add a few corner points for motion detectors and be sure to run a group of wires up to the ceiling for smoke detectors, C/O and glass breaks if you have windows. Run a 18/2 wire up into the attic for a 30 watt siren so everyone hears it. A date cable can then be ran from the alarm panel to connect to your telco block and monitored through conventional paths, or through a GSM Cellular path.
While you're at it, run some Cat5 cabling for cameras and home run them back to a head end location where you may want to add a digital recorder, monitor and keyboard. Have network ports located at all head end locations as the push today is to monitor alarms and camera systems through IP transmission if available. Map it all out and really think about what you want before you start boarding or finishing off the walls. Too many people think of security after everything is already built and that makes it difficult to do right.
Call me if you have questions or need a source for products in your area. I'll hook you up.
|
Awesome info. Thank you in process of trenching, very timely!