Intake/Guide Plates..
I saw you posted that you had a new Edelbrock intake...but, why do you need to change the guide plates..?? Is there an issue..??
Intake swap is pretty straight forward...prep the car for the project [fender covers, drain pan for coolant, have your tools organized, boxes/bags for bolts and hardware...cleaning solvents, rags, lighting...mostly common sense stuff.
-mark distributor location so you can re-install correctly
-you will need new intake gaskets, t/stat gasket, carb gasket [maybe]
-take some photos with digital camera as a reference before anything is taken apart...this will help if you forget where something goes.
-be careful with fuel lines and gas...
-work clean, take your time
if you do have to change guide plates...?? then the valve covers will need to come off..[maybe new gaskets here]...change them one at a time and try to get the pre-load adj. on the rocker nut to the same spot...you will have to an adjustment after they are all completed.
good luck
__________________
02 Berger 380hp #95
Lots of L78 Novas
Join National Nostalgic Nova!
70 Orange Cooler
69 Camaro
|