Spent some time swapping out the narrow traction bars for the correct era square bars from Lakewood. I have some 4* wedges coming and will hold off tightening things up until they get here. I haven't used the wedges before so I'm not totally sure where they go in relation to the lower insulators? I'm assuming they slide in from the rear (underside) and go between the lower traction bar mounting plate and the rubber insulator?
In any case, here's what the new square bars will end up looking like under the car. I'll finish up some pictures after I get the wedges installed and set the suspension with weight on the car. Inching closer here.