Thread
:
69 Z/28 Day II Project (Air Force Brat)
View Single Post
#
514
01-11-2021, 04:17 AM
NorCam
Senior Member
Join Date: Feb 2015
Location: Alberta, Canada
Posts: 4,191
Thanks: 2,587
Thanked 3,399 Times in 1,242 Posts
Didn't dyno this one Sam but would bet it's well into the upper 400 range. I started to open it up when I was finished the break-in period and ran it up to 6500 in 2/3/4 and it pulled like a freight train (real hard at highway speed and tires were chirping away). I hated short-shifting but hadn't finished breaking in the transmission either. The motor is good to go here, but I now have another fresh transmission to season before I start banging away on it. I dare to say this combo should be in the 475hp/475tq range (give or take a few points).
Here are a few shots of the weekend's work as I finished up the dash area and got most everything connected. Need to run the speedo cable tomorrow and get the console in there and then it's time to finish up the engine wiring and brakes. I should have the motor and transmission in later this week.
__________________
I like solid lifter cars, big cams and cars w/ 3 pedals in them.
Last edited by NorCam; 01-11-2021 at
01:48 PM
.
The Following 8 Users Say Thank You to NorCam For This Useful Post:
big gear head
(01-11-2021),
cruiserofland
(01-11-2021),
Crush
(01-11-2021),
dykstra
(01-11-2021),
HawkX66
(01-11-2021),
olredalert
(01-11-2021),
RPOLS3
(01-14-2021),
Xplantdad
(01-11-2021)
NorCam
View Public Profile
Find all posts by NorCam