69 Z28 rear leaf spring centering bolt/pin

**Danzo** · #1 03-18-2018, 12:07 PM

Is there a special bolt/pin to use when reassembling the springs?
Thanks.

**enio45** · #2 03-21-2018, 04:09 AM

yes

**Salvatore** · #3 03-21-2018, 12:02 PM

well tell him what it is Eddie. Show him a picture. Typical Italian with the one word answers. geeze LOL

m22mike · #4 03-21-2018, 03:01 PM

The bolt has a round head that engages the round hole in the rubber spring pad , the nut may need to have it,s points ground some to fit the other half of the rubber pad. There are a bunch on ebay. And some auto parts might have them. Dorman makes the too. And Summit racing has them.

Mike

https://www.ebay.com/itm/Leaf-Spring...xaeL0K&vxp=mtr

**earntaz** · #5 03-21-2018, 05:30 PM

Any spring shop that's worth a damn should have these -- although ya' may have to cut to get the right length ... TAZ

**Lynn** · #6 03-21-2018, 10:52 PM

I just ground the hex head into a circle on mine. Doesn't show once installed.

m22mike · #7 03-22-2018, 03:06 PM

And we're they 1/4" on the Camaro ?

Mike

**enio45** · #8 03-22-2018, 03:15 PM

Sammy, sorry....i only answered the question because i don't have current access to my parts right now....yes they are unique, the pics above and both incorrect from my memory.

The did not have a slot in them and they were were not hex either. Round head with a flat top...exact height about 1/4 to 5/16 if i recall on the head.

Mike, i think they were 1/4.

When i get to my stuff ill post a pic

OKKKKK....Sammy was this better??

**Danzo** · #9 04-08-2018, 11:14 PM

Does anyone have an original that they can post a picture of?
Thanks.

The Following User Says Thank You to Salvatore For This Useful Post:
m22mike (03-21-2018)

Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars.