Dick Harrell stripe kit????

[1970 1/2 RS/SS Camaro]

I hope this is the right forum... I'm doing a old school build on my '70 Camaro. And I would like to use the stripes thats on the 454 Dick Harrell Camaro. I am wondering if anybody knows the dimentions on this or know where I could find them. Maybe some one has some good picture of the car.
Thanks

[Lee Weber]

Mark, you can go by the pics in the link below, or contact the owner of the site for more detailed info:

http://sandlinmotorsports.com/1970_d...454_camaro.htm

[1970 1/2 RS/SS Camaro]

Thanks. Thats the Camaro that is in one of my back issues of Camaro Performers. Do you know if they reproduce Dick Harrell stickers?

[Kim_Howie]

I don't think they do. The stripes were sprayed by Dick's painter back then. Kim

[1970 1/2 RS/SS Camaro]

Kim, don't have a Harrell/Gibb car? (with the stripe on the side) If so, do you know the dimentions on it?
P.S. You have a bad a$$ car...

[Kim_Howie]

Mark, Starting at the rear of the car they start 2" from the q panel and tailpan seam They are 4.5" wide . The middle of q panel it's 6.5' wide. At the door and q panel lip it's 6" The back of the door it's 6' wide, the middle of the door is 3/4" and front of door is 5/8' The front fender at the back of it it's 5/8 and narrows to a 1/8 round end. The stripe on the front fender is 22" long. hope this helps

[1970 1/2 RS/SS Camaro]

Cool, thanks

[1970 1/2 RS/SS Camaro]

Kim do you buy chance have any close up picture(s) of the stripe?
And I'm just wondered do you have a grump lump on your hood?
I just got my 'glass front end and a grump lump hood, but I'm not sure where I'm going to put the scoop hole at. I've seen them on the bottom most of the time but I've also seen them at the top. Does it make a differance?

[Kim_Howie]

Mark send me your E-Mail

[1970 1/2 RS/SS Camaro]

Done...