Dedicated to the Promotion and Preservation of American Muscle Cars, Dealer built Supercars and COPO cars. |
|
|||||||
| Register | Album Gallery | Thread Gallery | FAQ | Members List | Calendar | Become a Paid Member | Search | Today's Posts | Mark Forums Read |
|
|
|
Thread Tools | Display Modes |
|
#1
04-12-2025, 03:14 PM
|
||||
|
||||
Correct length speedo cable ?
I have converted my '67 Camaro from PG to Muncie and am attempting to get a correct length cable to run in the original location it would have. This seems to be more difficult than it should be. I can't find a definite answer and get anywhere from 62"-71".
The AIM indicates the part number as 6454863 and searching that still comes up with conflicting info and lengths. Looking for correct length and info on where to obtain it. Thanks SYC
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles 
|
| The Following User Says Thank You to Too Many Projects For This Useful Post: | ||
juliosz (04-13-2025) | ||
|
#2
04-13-2025, 05:06 PM
|
||||
|
||||
|
No one has needed to replace an original Muncie cable and found one close to the correct length ?
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles
|
|
#3
04-13-2025, 05:42 PM
|
|||
|
|||
|
61 to 63 inches, depending on who you believe.
__________________
Don't believe everything you read on the internet ... Ben Franklin
|
| The Following User Says Thank You to Lynn For This Useful Post: | ||
Too Many Projects (04-13-2025) | ||
|
#4
04-13-2025, 05:43 PM
|
||||
|
||||
|
|
| The Following User Says Thank You to scuncio For This Useful Post: | ||
Too Many Projects (04-13-2025) | ||
|
#5
04-13-2025, 08:44 PM
|
||||
|
||||
|
Yep, I read all that, Tony, but since it was for a '69, wasn't certain if the length was different with the screw on end at the speedo,vs the snap on end ...
I've been looking at vendors for a 63" cable and they don't seem to exist. I have one here that is a hair over 61", but I think it was on the car when I got it and it was a little too short with the Powerglide. Maybe it will be OK with the Muncie in the new location? It has a paint mark 29" from the trans end that may be the locator referenced to in the AIM for the center clamp. I have a Balkamp replacement now that is 75" and I'd like to get a shorter one.
__________________
Mitch 1970 Chevelle SS 1966 Chevelle SS 1967 Camaro ss/rs 1938 Business coupe, street rod 2000 FXSTS, original owner, 13k miles
|
|
| Thread Tools | |
| Display Modes | |
|
|
Linear Mode
